RasterCalc

General Information:
The program RasterCalc provides a fast calculation of uniform spacings (pitches) at a predefined length. Thereby also different edge distances where considered.
For instance, with RasterCalc it`s easy to make a calculation of spacings for drill-holes, oblong holes, welding seams etc. without time-killing trying.
Due to the common user interface this program could be used at any all-round cases.
After input of the necessarily values and parameters you receive all possible results shown in a table.

Liability:
This program was created with care and all declarations are checked. No liability can be taken over in any case of incorrect or incomplete declarations. The author is not responsible in case of profit loss or damages occuring by using this software.

Copyright:
Full-Version:
The program RasterCalc with all files belonging to it are protected by copyright. All rights are reserved. Unauthorized copying of this program or parts of it with all files belonging to it is strongly forbidden.
Per registered licence it is allowed to install this program only on one computer. If necessary it is allowed to make one backup copy.

Shareware-Version:
The Shareware-Version of RasterCalc is made for evaluation purposes without charge (10 allowed program runs). If you want to use this software after the evaluation period you must pay a registration fee.
The Shareware-Version is almost fully functioning. Besides at start and exit of the program you will be informed, that you are using the Shareware-Version. It is desirable to give the Shareware-Version of RasterCalc to friends and colleagues.
It is allowed to publish the program RasterCalc - Shareware-Version with all files belonging to it, but it is not for sale. It is strongly forbidden to make changes at the program with all files belonging to it or sell the changed program without the prior permission of the author.